Ref 09-009 - Bridge cutting machine COMANDULI BISSO E 350

2008 year Location - Italy Condition- good


medium-sized electronic bridge sawing machine for cutting stone material Very strong cast iron structure, mechanically machined with high quality and precision processes. Spindle sliding on an assembly of linear guides and pads with recirculating balls, well protected. Bridge traverse on special steel guides with ball rollers in oil bath. Bridge traverse kinematic motion through a pinion/rack system in oil bath with variable speed. Spindle lifting on round guides and bronze bushes with screw kinematic motion with variable speed. Disc holding electro-spindle with possibility of manual slant up to 45° with slant visualization. Turntable on a special ball-bearing pivot block, particularly sensitive, with a full load too. Particular attention has been devoted to the selection of the electrical control panel parts: the result is a machine with fast movements and soft at the same time, and particularly silent. The machine is supplied with water system with solenoid valve and flow-indicator, which stops the machine automatically in case of water lack. Electrical control panel on floor level and pensile push button panel. Linear laser for material alignment and cut indication.

Technical Data
Bench length mm 3.500
Bench width extension brackets m 1,40÷1,80
Bridge transversal stroke m 3,50
Spindle longitudinal stroke m 4,00
Spindle vertical stroke m 0,45
Disc maximum diameter m 0,65
Disc shaft diameter mm 50
Spindle motor power kW 15÷18÷22
Feed motor power kW 1,5
Traverse motor power kW 1,0
Spindle lifting motor power kW 0,5
Machine net weight Kg 5300